Recent content by Rockwell

Thank you much for that tip! I did at one point and didn’t see any noticeable oil swirling but will look for that again. Is a problem in the pump a possible cause of my control issues?

Thank you for the kind replies. I have installed new cylinder with new style piston. No leaking from top side now but foaming from inside of pump as back blade drops. have installed new cam follower pin and adjusted linkage with Zanes thang.

Well I put the lever in implement control position but it burst my excitement by still only controlling with top inch of quadrant. When control lever is moved slowly to within inch of quadrant top the back blade starts to lift and shudder and moves to total up position without further movement...

Thanks so much for reply’s. did replace the follower pin, cylinder, piston and o ring etc. but I do in fact have lever in draft position 😳. will try that tomorrow for sure. My blade drifts down to ground in about 5 minutes. No dripping from above but there is foam riding out of my pump...

is it normal for all control of lift arms to be in the top 1” of the quadrant? I am having awful time trying to level some sand with control being difficult. thank you