Recent content by saskman49

I am in the process of possibly buying a 1976 1070 with powershift this friday and I have no clue as to how to properly operate the PS. Could one of you Case gurus school me on the proper usage of this shifter. I have found some of the don't about them but still don't fully understand using it...

I have been wanting a bank mower that I can attach to my 2320's 3pt and basically have a hyd cylinder push the mower out to the side to drop down over a bank similar to a couple other projects in the hyd section. My problem is 1: using a pump and hyd motor driven from the PTO is wayy over my...

Has anyone considered adding a second pump on a 2320 and splitting the ccts they way they are on a 2520/2720. On the surface dosen't seem like such a large task but there must be something I am missing. It would seem adding a seperate pump with abt 3gpm to run the steering would not be that hard...

I added a set of hyd ports to the back of my 2320 so I could control a hyd top link or the hyd chute on my blower, raise and lower a scikle bar mower or any number of other tasks. Here are a few pics of the install. Total cost was a little over 800 cdn and it works like a charm.

I am looking at the 28hp T1110 NH CUT with a 60" mid mount mower, loader and 48" tiller. The dealer has offered it to me for 15k with my Deere X500GT as a trade in. Are these good units with a good reliabilty record, I know they are a new model this year and seem to compare to the Deere 2320...

Well hello all as this is my first post here. I am currently trying to decide on a CUT for our acreage which consists of abt 5 acres of lawn mowing including around our dugout and old train track area, and 10 acres of fields that at some point will be turned into a Saskatoon Berry farm and a...