Recent content by ScottB450

With this piece attached to the gauge removed, the below pic is looking in. It seems like all the flow is being diverted into the differential. I can start it and see fluid flowing into the case. It hards to tell in the pic, but these parts are covered in oil. I'm not sure what you mean...

.........

I took a break from this for a few weeks. Decided to dive into it again today. I did remove the lift cylinder, started the tractor to see how much flow I was getting in there. I'm not sure if it's normal, but it has alot of flow. The spool valve is covered with oil coming down over it. I've...

JC, No problems. I appreciate the help. I pulled that valve apart. One of the ball bearings had a little rust but that was it. I didn't have any oil coming from the hole.

Here is the internals. Spring looks good and no dirt. I have oil flow here. Bone dry here. Thanks!

I have a pressure gauge. Has read zero through all this. I pulled the valve off and oil came shooting out of the hole I'm pointing to. So, I'm guessing this leads to the spool valve? Thanks for the help! Scott

I pulled the line directly off the outlet of the pump. Started it and it has good flow! Thanks!

I went back and checked my work. Looks like the seal is ok. I'm not getting any oil to this part. The assemby grease is still on it and there is no hyd fluid. Any ideas from this? Thanks