Recent content by severtki

Picked up a 5' unit for use with my Kubota B series, and it appears the u joints are pretty well shot near the implement (bad chatter on the shaft when even slightly out of direct alignment). Can't quite tell how to remove and replace drive shaft, looks like some kind of set screw, but can't...

It must be a valve lever. I'm guessing the "cans" are here (picture below), just below the middle of the picture, and once removed, I'll be able to see inside the end of the valve to clear any blockage? If so, do I need to know anything before unscrewing them or do anything after replacing...

I've got a Kubota B3300su and the FEL control will operate everything except the uncurl motion. When I move the joystick and look at the movement in the valve control, I can see the spool valve pull out for the curl operation, but it doesn't seem to want to move in for the uncurl operation --...

Kubota B3300 -- suddenly can't curl bucket. Other three functions of FEL joystick (raise/lower arm, uncurl bucket) work normally, but when I move the joystick to the left, it goes over easily w/out engaging anything. No hydraulic leaks that I can see, hoses seem to be OK. I'm guessing there's...