shirleyujest's latest activity

I use gr 2 bolts. I want the part that breaks to be the easiest to replace, and the cheapest. I usually break 1 bolt every time I use my...

I dunno...I did years of loader work with a gear IH 574... And I'd take my current HST over that any day. Knees or no knees 😂 It all...

Used only on Sunday by old lady on way to church?

In had the same issue and weighed my time and effort for something that may not work and bought the pins from the dealer.

You might be money ahead to buy a different tractor to run that mower or get a pull type mower for your 806.

I sometimes use my grapple hooks to turn a compost pile.

If you have pallet forks, you might try using them to fluff the pile. There is less resistance as the compost falls between the forks...

Another possibility is the Shaft outside diameter is much smaller than the Collar inside diameter. This would allow excessive play in...

The bolt simply holds/connects the PTO shaft onto the gearbox input shaft. The collar on the PTO shaft that goes over the input shaft is...

If that bolt were meant to be a "shear bolt", there would be a snap ring to keep pto hub from coming off the gearbox.

I think it is similar to using a cold chisel to cut a steel rod. repeated blows cutting the loose bolt. The grain unloading drive on my...

To me @Windblown's assessment is accurate, the images suggest the fracture to be Fatigue Failure from insufficient preload during...

Since most decks are belt driven the blades likely won’t in the same position after a couple minutes.

I took for granted that they need to be tight.

Maybe the brush guard is wonco.