skipmarcy's latest activity

All you have to do to chase those threads is put some good old axle grease on your tap - and even if you were to get a tiny bit of...

I worked on mine over 18 years ago and I've slept since then, I'm 70 years old and my memory isn't quite as good as it used to be ! Like...

If your loader is a ML112, the rod has a large flat washer welded to it on the bucket end and mounts to the upper bucket pin. You can...

OK, it was April 2005 that I purchased the ssqa adapter & bucket. I bought it thru a Mahindra dealer but it was manufactured & shipped...

I know it's a long time ago but I purchased the Mahindra ssqa "tool carrier" in 2004 for $600 for my ML112 loader. I also bought the...

I would try some carb/choke spray, let it soak some/respray and try a plastic scraper - be sure not to get the choke spray on other...

The spool (the actual rod that moves back & forth thru the valve) has a radiused groove in it. Under the detent cap is a spring with a...

Fortunately for me my Country Clipper has the stand-up design and I clean under the deck after every mow, wet or "dry". Even in the hot...

My Country Clipper has non-greasable, iron, rebuildable spindles. Don't know if the bearings are fully sealed or non-sealed and factory...

Water heaters will make similar noises if you have sediment build-up getting close to the lower element and/or an anode rod gone.

Should have bought a joystick model, like my Country Clipper ! Operating arm on an armrest and using 2 fingers to mow. I can bend way...

On my very old Howse 6', the bolts also have a "pinched-up" key made into the tapered shoulder of the bolt to keep the bolt from turning...

The govt. pot farm has been at Univ of Miss. in Oxford at least since the early 1970s, possibly before that.