Recent content by slim357

Do they still sell thaese? Is there a way to modify the planter? how do I change the bearing? Is there a spacer between the bearing and housing?

i got several different plates also

no, I got several different plates

Not sure what year. All the numbers I could find. Thanks.

I took these photos of the corn planter I purchased. Not sure what year or model.

Just bought a Massey loader for my Massey 150. Not sure of model. Needs new hoses. Looks like hoses are attached to lower loader arms? Why? Will post model of loader later

thanks! Did put all together never found balance marks. Love this site. Lots of knowledge here.

OK! I didn't know I had to mark my clutch pressure plates before taking it apart. Will it cause all sorts of broblems? tham nks doug

Any Ideas on how the two Bellville plates should face when putting pressure plate together?

anyone put in a new wire harness for their 8N lately? I bought a new harness but some of the colors do not match the schematic in the shop manual. I have a red, black and white coming out of one end of harness and 2 reds a black and a yellow out of the other end. Which way is front? Thanks, Doug

putting my 8N motor back together. Oil hole is on the front of rod not either side(where bolts are located) Does the hole go to the front of tractor or rear.? Thanks. Doug

Draft control doesn稚 seem to work. Lever moves freely and doesn稚 seem to be engaging any other mechanisms.

I have a 1975 Ford 3000. I got that much from the numbers but cannot decipher the rest, any one help here? 5B03B C452342 thanks, doug

Bought a 2000 model ford tractor and it has taller tires. My fenders are off but when I checked the mounting the fenders touch the tires. I see some fenders have a taller mounting bracket. Can I purchase these taller brackets without having to buy 2 new fenders?

Just a question concerning 3pt on this tractor. When I engage the 3pt it either goes all the way up or all the way down. Am I supposed to be able to stop it going down at different levels? Is the an adjuster somewhere? Thanks for reading Doug