Having issues with rear 3 pt not lifting with load on it at idle, works fine when engine rpm is above 1800 rpms. 2003 TC45D w/FEL The FEL works fine so I decided to tear into the HPL valve thinking that the o-rings behind it may be leaking. that was not the issue. but got a couple questions...
Well here is the situation, recently purchased tractor with 240 hrs. serviced everything on 300 hr service and put tractor to work. at 275 hrs the temp gauge started to go to the cold side after tilling for 1 hr, tilled for another hr and gauge was running at the bottom. read forms and found...
Does any know where you can find the service manual online or flow charts for the hydraulic system? have issues with 3pt and trying to troubleshoot it. it has 2400 lbs of pressure on rear remotes, but will not lift much on 3pt at idle
Just purchased a 84" SBX Bushhog box blade and was wondering if they made a mistake on the price? Paid 1000 dollars for it, does that sound about right or is that a good deal?
Thanks Steve
I recently put a 800 lb tiller on the back of my newly acquired 2002 TC45 and it will not lift it at idle, if I raise rpm up to 1400 it will lift it slowly. i have searched the forums and believe this could be caused by sticky pressure relief. also is there a shim kit available? and do you add...
I just purchased a used 2002 TC45 with 230 hrs and have put 10 hrs on it since. And was wondering if this is normal, when starting the engine it surges at idle about 300 rpms from 700-1000 rpm. Is this normal? It lasts about 1-3 minutes depending on the ambient temp (30-60 deg F) before...