Recent content by Spiros

  1. S

    Cleaning up riverfront property

    I am planning to clean up two acres of riverfront property that I have been attempting to sell over the past two years. It seems that not everyone has the same vision that I do regarding property potential so....major redo. The property is littered with trees of all sizes and stumps. Besides...
  2. S

    Older Yanmar 2210 bd

    Here is a photo of the transmission dipstick and its location. Hope this helps.
  3. S

    Good morning!!!!

    39 degrees here in Memphis, TN this morning. Fencing today and general cleanup.
  4. S

    Good morning!!!!

    Good morning all, 93 degrees and 45% humidity here today. 36 inches rain this year so far and 4.5 inches this month. Going to take it easy today.
  5. S

    Yanmar 2210 Engine Seizing...

    I brought home a Yanmar 2210 (Shiny as a new penny) which started and ran great for until asked to work. After about 15 minutes of work, (finish mower or bush hog) the engine would overheat and begin to seize. Great quantities of black smoke would pour out the exhaust and no matter if you...
  6. S

    Grapple  Loader Hydraulics

    I have installed a loader on my TC33 and switched the relief/diverter manifold to supply said loader. It works great but my rear lift has ceased to operate. Upon reading the manual, it states, the diverter valve in the 10 oclock position allows auxillary hydraulics to operate and in the 2...
  7. S

    Everything Attachments

    I just had to write this note to praise the folks at EA for the way they handled my recent order for a TC33 loader kit. It was ordered on line and I was contacted by Travis to answer/verify a couple of things. Travis said I should receive the kit in a week to a week and a half. Yeah right! I...
  8. S

    Hydraulic Tools

    I am relatively new to the hydraulic world and am slowly collecting the correct skillset and tools required for the job. Question is, I received my adjustable flow diverter and I do not have an allen wrench large enough to remove the plugs. I tried a bolt head and vice grips....no luck. May...
  9. S

    Hydraulic Pump Volume Reduction?

    In an attempt to attach a backhoe to my TC33 I ended up with a Prince PTO pump rated at 21gpm. Even with the engine idled down, the outriggers will go down so fast they dig holes by themselves. In an attempt to feather the controls lightly to gain some form of control, the pto pump clicks very...
  10. S

    Quick Hitches  PTO driven well pumps

    Hi everyone, I notice that across the river in Arkansas when the rice farmers flood their fields, they sometimes pull a tractor up to a well head and attach a PTO shaft to a well pump and go to town. I was wondering if those well pumps, PTO driven, are available on a small scale? I want to...
  11. S

    New Member

    Hello from West Tennessee. I am afflicted with the tractor bug. Yanmar YM1900 for 20 years. Nothing more than oil and filter changes. Yanmar YM2210 Usually running. Ford 1963 Diesel 2000 with an old loader (mr. leaky) Garden and perform other tasks with these machines. Spiros
Top