So I made this sometime ago: New video by spiro stats
It can be found here:2003 Kubota B7500 mid to front pto conversion.
My front PTO spins at 2500 rpm
It works good but I have to run at 2500 rpm engine speed in order to get a decent amount of air flow. I tried increasing the rpms with a belt...
Hi all. I have a B7500. I made a plow mount for the front loader and attached a galvanized 6ft plow I was able to buy. I used it the first year with no problems but wasnt able to complete the installation of any angling mechanism. This year I decided to take this up and wanted to use a double...
First here is how I managed to pull back the spring in order to load the belt without having to disassemble anything. It was completely effortless and i pulled the spring way past it's regular resting point due to having a short belt. Hope this helps someone. I would highly recommend some...
90% done.
Works great. Not sure why this configuration isn't more popular. It was definitely worth the effort. Wheels are from harbor freight on two bolts. Can easily be changed out for about $15 a piece. Will look for a wider one in the future and might add suspension. I can bolt anything on...
Made progress, Works good. Self limiting height on loader arms. made a brace to eliminate pivoting out of the shaft. Need to fabricate swivel wheels prob about 5-6 inch to clear uneven ground. I think I will use the guides for the existing ones to adjust the height and connect them in pairs with...
made some progress....need ideas on how to hang it from the loader arms or tractor frame or both. Will still have to fabricate big swivel wheels etc..stay tuned
Hi I purchased an almost new emax25m belly mower (I think it's made by ameriquip). I was going to front-mount it on my Kubota b7500 until I realized that the rotation is wrong!. ( I already have a mid to front pto setup...
https://www.tractorbynet.com/forums/kubota-owning-operating/418647-2003-kubota-b7500-mid-front-2.html#post5723768
Scroll to post# 20
PS How can I change the thread name to a more general title so I can keep all my mod posts together?
FYI
I Made some adjustable width bucket forks when I needed to move my BBQ close to the garage for repair. Didn't like the clip-on types because I suspect they would damage the bucket. I have used them many times since and they work great. Not done yet. I left the back side untethered so they...
BTW the front bearing support braces should have been built to fit on the inside of the bumper. I lost about 1/2" on my turning radius. No big deal since I try not to steer this tight but I now have to figure out a way to limit the radius to what is allowed so I dont accidentally destroy my...
Too lazy or didnt wanna wait so I spot welded a pto adapter sleeve to the 1" shaft to try. Works good. I need to built a rotating chute now to direct the flow