Need help troubleshooting a power steering control valve on a MF 231. This is the type of valve that moves up and down as the steering wheel is turned left and right. The tractor has no PS in either direction, and there is strong pressure at the front steering cylinders. I have not tried...
Suspect this one is bad. Moves as it should as the steering wheel is turned left and right. Strong hydraulic pressure on both front cylinders. Still, no power assist in either turning direction.
Can the control valve be troubleshooted without removal? What is the purpose of the two large hux...
The water pump on my 2304 is leaking and needs replacement.
Looking for any and all tips from those who have done it. Wondering if I'll need to pull the radiator and if so, will it be a knuckle buster?
Thanks in advance.
I need to replace the driver right side rear tie rod on my E2304. After separating the tie rod for the steering linkage, I didn't see a nut or any evidence that the tie rod itself was screwed onto the steering rod that runs to the front. Rather, it appears to be welded onto the rear end of the...
The pointer on the tachometer on my Hinomoto broke off from age and wear. An exact replacement is obviously going to be difficult. Tachometers for other American-made tractors are available via e-bay and other sources. Does anyone have experience replacing a Hinomoto tach with one from another...
Well, one of the bulbs in the headlights on my Hinomoto bit the dust this past weekend so I went looking for a replacement. It turned out to be a big mistake trying to get one from the local John Deere dealer. They might as well have told me to go to %$#@ when I showed them the old bulb and told...
I want to put an over-run clutch on my PTO and have noticed they can vary a lot in price. Tractor Supply offers one for about $65 but I have seen others on the net for closer to $100.
Should I steer away from the cheaper types?
Thanks.