spruce Deere's latest activity

Yes, bigger pump, but then also bigger engine required to drive it, since same pressure at higher flow = more horsepower demand. Also...

Husky 395 xp 24 inch bar for large stuff, greenworks 60 volt with 20 inch bar for not real big and Ryobi 40 volt with 16 inch bar for...

All Stihls: 500i, 441, 026, 211. 28" with square-filed chain on two big ones [RSLF], and 18" RS full chisel on others.

Stihl 500i and 261c

Congrats on the new bota... I hope you get many hours of pure pleasure out of it.

Yep, 48 inch deere 403 model rotary cutter. Got new tail wheel guts, blades sharpened and new full synthetic gear oil in the gear box in...

B2401 with the jd 403 rotary cutter. Put 2-1/2 hours on it mowing with it yesterday. Went real good till my phone died, and so did the...

4570man, that's a pile of wood!! I was surprised with just an extra hand from the son in law how much we got split, but your pile is...

I had a 044 stihl back in 95'-96'.It was given to me and been ran hard. I ran it before it lost enough compression getting it started...

My main saw is a 372xp. Its a '98 model on its first rebuild. My standby saw is an even older 288xp, I owned them both since new, both...

The canopy is wider than the tractor! Its raining now and other things have came up. So it will be a little later today before I get...

Got the canopy put together and installed this evening. Its a red rooster canopy. It has a much more simple angle adjust/ removal set...

Ladies and gentlemen, as promised some photo's. Tomorrow it will dawn a canopy, and the 401 rotary cutter.

Some hang-up with the shipping, Thursday is the day now....

I found TRC 880 crown and chassis grease and started using it. No bleeding or oozing oil from the grease from what I have seen. It is...