SPYDERLK's latest activity

Not sure the name, but it is used for 3 point hitch ground engagement control. It senses compression on the top link and makes...

DO NOT use a standard cutting tap! Instead use a thread-forming plug tap with an appropriate lubricant. It does not cut, but instead...

Torch.

The issue is due diligence by the field owner. The field should be kept short by frequent mowing and perhaps tedding until you till. It...

Yes. I noted that the subject of covering the full tire track came up though. This introduces a problem with cut of the grass flattened...

Best quality cutting I ever got with a bushog was 5' on a JD2010 tricycle. The hog didnt cover any wheel but the front. Mashed grass...

Hmm. I have a Woods HC-60 that came used "like new" with a 1/2" Gr5 shearbolt. We have sheared 2 of them. -- Not myself. I only did the...

Im thinking eshered is a convoluted typo of sheared. Probably AI involved.

Every double shear situation calls for having the bolt shank across both shear lines.

Well, since a "shear pin" is a grade 2 bolt was the issue the Harbor Freight bolt specifically?

True. But no danger with the instructions you gave. Just the chance of interpreting very high ohms as a fault in this low voltage condition.

Maybe the original is metric; 75 or 76mm?

Dont use one of the sensitive/hi ohm scales. A resistance of ~10K or so, while truly a resistance, should be viewed as an open...

Pull the positive cable from the battery. Place the meter set on ohms between the positive and negative cable ends. Check for...

Then there is unwanted height added to a top heavy item. McCarr has some ~2" that you only lower to contact when you want to roll. Ive...