Recent content by srodster

  1. S

    TC35D cuts out or won't start after getting hot

    Thanks to everyone for their comments. I believe the issue has been solved w/ the new glow plug timer apparatus, since it has multiple functions besides the glow plugs. The white wire in my original message on the glow plug timer goes directly to the starter. So, I received the new timer, and...
  2. S

    TC35D cuts out or won't start after getting hot

    I did order the glow plug timer, since it has multiple functions and is one device responsible for getting the voltage to the starter solenoid. The part number for it is SBA385870301. Randy, curious if you know the "starter switch" part number you referenced? (In case the glow plug timer...
  3. S

    TC35D cuts out or won't start after getting hot

    Recently the last couple months, my '03 TC35D (1400 hrs) when driving along sometimes cuts out (but never shuts off) and most recently when after mowing for 2 hours or so, and I shut it off, it won't start. I did some digging and trace back on the wires. When I run a hot jumper to the starter...
  4. S

    NH TC35D Fuel sending unit always pegs full

    Thanks for all the replies! A new fuel gauge arrived today from Messick's, and that was the issue. Installed it and tested it prior to install, and everything is good to go....., However, that was a tough invoice, conveniences of life......., $192. I could have played a lot of scratch off's...
  5. S

    NH TC35D Fuel sending unit always pegs full

    Thanks, an update. 1) I disconnected the wires to the sending unit and removed it, and got 33 ohms (full/all the way up), and 253 ohms (empty/all the way down). Conclusion = sending unit ok 2) With the wires still attached to the sending unit, I ran another ground wire straight from sending...
  6. S

    NH TC35D Fuel sending unit always pegs full

    Recently my TC35D ('03/750 hrs) fuel gauge was showing the actual fuel level, and then while driving, it would peg full. Now if just pegs full every time it is started. Trying to understand if it's the sending unit or a wire issue. Wondered if anyone has experience with this? I have removed...
  7. S

    NH T4.75 hydraulics and a case drain line.....

    I have an implement that has 3 hydraulic lines. 1) Pressure 2) Return 3) Case drain line So, I have a set of remotes to hook to for the pressure and return. Does anyone know where the best spot is for a case drain line? I have looked and it appears the fill spout is threaded, so I could go...
  8. S

    Rotary Cutter  Bush Hog 286

    I bought a used Bush Hog 286 and don't have a manual. Does anyone know if there is supposed to be a chain that runs from the rear floating tire to the 3 point hitch arm. It looks like it is made to accept one, but one was not on the mower when I got it. It does have the stabilizer bars that...
Top