Recent content by srossman

I went out and looked at mine last night and the backhoe is angled back. I tried to take some pictures, but I don't know how well they show the angle.

Ok, so I've been following another thread in increasing the relief valve pressure on my BX 23 and I've tested it and found that my pressure is down a bit. I've searched and searched for the location to put in a few shims to increase the pressure and I can't find it. Can anyone give a very...

Does anyone have any experience with the j-bar spider spd60 finish mower? I'm going to look at one this afternoon and just wondered if anyone had any opinions? Thanks Scot

Hi all, I'm looking for any personal opinions from anyone who has a propane or wood smoker. I don't want to build a complete building just for smoking, but would like something to smoke some of my venison (if I can get one this year) as well as some bacon, turkey and even would like to cold...

Ok, So It has taken me a while to actually getting around to post this project, but I thought some might find it interesting. First the back story: Back in December of 2006, my tanked water heater suddenly began leaking. So I did the smart thing and turned the water off and started looking...

Ok, So I'm just trying to get feel for what would be involved in this. I bought a trailer last year that has hydraulic drum brakes. If I wanted to convert them to use electric brakes, what would be involved on the trailer. The trailer already has the 7-prong rv type connector, I think the...

Hi everyone, I was hoping someone could shed some light on a question that I have. I'm in the process of putting gas lines in my house and am trying to figure out the proper size to buy. For right now, I installing a tankless water heater which requires a 3/4" line. In the future I will also...

So I was at an auction over the weekend and picked up a used Howard HL40 al tiller. The only problem was that when they were moving it out the barn, they bent the PTO shaft. So my question is how do I fix this. Can I have the shaft straightened? Or will a replacement shaft work? Thanks for...