Ok. Worked on the tractor tonight. It's working correctly. Mostly. LOL. The position and draft levers rides in the quadrant and pick up some rollers. Well tonight I relooked at everything. Turns out that the position looked like it was in the correct position but it wasn't. It needed to go into...
actually he starts talking the good stuff at about 6 min in. I wish I would have found this video prior to my second install. But now I have a good idea.
Once I had the lift cover installed I filled it with oil and left the side cover off and started it. Draft raises and lowers the lift arms. Position does not move the barrel forward. In fact it doesn't do anything. I did notice when the arms are completely up it sounds like there is a load on...
Installed and the same problem. I guess back off again. Another day perhaps. The barrel roller is in correctly stan pipe is where it is supposed to go. When I take it back off I am going to remove the lift cylinder housing. the leavers appear in the correct position. I have watched the videos so...
I took the lift cover back off. The lever arms appear to be in the right spot but I am looking into it. As I move the draft lever back and forth I can see the arm hitting the dashpot. When I just use position the lever arm moves slightly but I don't see where it is doing anything to engage...
Hi, I knew about the roller based on the videos I watched. I took it off before pulling the cover. But I am wondering if I installed it correctly etc. I really thought this was going to be a straight forward job like a 8n or a 9n ford. I am home from church and I am going to get started. but it...
Oh, and I did not unbolt the linkage bracket. it came out when I pulled the cylinder off. So if that is the case shouldn't everything be in proper adjustment?
So when I took the lift cylinder off the lift cover I did it without the manual. As a result the two big springs went flying and the small spring came off as well. I watched a as many videos as I could to see how everything went back together. So when I installed the lift cylinder everything...
Hi,
I pulled the lift cover on my 1967 165 Massey to put new rings into the lift cylinder. I also added a replacement relief valve in the tractor case. When I put the cylinder on I thought I got the position and draft control lever arms in the correct positions (based on the manual). The...