Recent content by Steelstring

Where can I find lower control arm parts or a like for like replacement for my ct235? I was doing some rough brush hogging and shed some parts in the field somewhere. I知 struggling to find a replacement arm or parts that are the same style. Thanks in advance!!

So I had the dreaded battery leakage and didn't notice it for a bit. Now my positive battery terminal clamp has disintegrated. Is there a direct replacement anyone would suggest? I'm thinking a 90 degree crimp connector and a standard replacement terminal clamp with a 3/8" post. If I go that...

Any recommendations for a baler for the ct235? PTO HP requirements for older used balers are a little hard to find. I would think the 26.5 HP on the ct235 pto is not going to be enough for most balers. Thoughts?

So a mud dauber wasp decided to take up residence in the key hole of my Series 1000 tractor. I've tried a small wire brush and compressed air, but i still can't get enough of the mud out to get the key in the hole far enough to turn it! :thumbdown: Any suggestions? Can you take those key...

I am coming up on my 50 hour service on my CT235 and I've been watching the recent threads on the fluids and filters. Is it really legal for Bobcat to void the warranty if you don't use their fluids?

This is our first winter with chickens. We have a nice chicken coop that is fully enclosed. When it starts to get cold, do we need to provide any heat for them? I have a heat lamp in there, but I'm not sure its really necessary. What do any of you with chickens do over the winter to keep...

Can you adjust the Pressure relief detent spring to center on a Prince LS3000 log splitter valve? The cylinder return detent only works about 25% of the time. It usually pops back to center before the cylinder is fully retracted. Thoughts? Thanks!

I just bought a Generac 7500 watt generator under duress this morning due to an extended power outage. I've been planning to buy a larger generator for a while and this finally pushed my over the edge. So here's the question: What have you been able to successfully run on a similar size...

After months of talking with all of you and shopping around, I put a down payment on a CT235 at the dealer today. Here's how its set up: two rear remotes 7TL Front-end loader with Bob-tach R4 tires (after much debate) Deluxe suspension seat Rear work light Slow moving sign They had to order...

I am about to pull the trigger on a CT235. I am interested in a backhoe, because everyone needs a backhoe, right? I really like the looks of the Woods bx-70, but I can't find much info about the bobcat backhoe. With the 0% financing on attachments, it is appealing. I am always happy to use...

Well, I'm going to take the plunge! Now that Bobcat has reinstated the free loader program, does anyone have a recent price quote they can share? What price should I expect for a reasonably good deal? Here is what I'm thinking: CT235 HST Free Loader R4s Two rear remotes Upgraded seat...