I have a 2006 BX2350 with over 900 HRS. I took the tractor in for service to the power steering. It needed new seals in the cylinder as the oil was being bypassed. I asked them to check over the tractor as well. They found there was a oil leak behind the front flywheel. There is a plate thats...
Hi everyone! I let my neighboor use my BX2350 with frontmount snowblower so he can do his laneway. It takes about 1/2 hour each blow. But this winter with so much snow he must of used it over 40 times. We do a trade off and if I need some help in the summer he helps out.
I want to be fair and...
This is very strange!
Took loader off tractor and was working fine
Put on front mount snowblower to test and get ready for the snow.
The Hydraulic Shoot rotator goes only in 1 direction.
I reversed the 2 center quick disconnects and it goes in the other direction.
Then I connected the shoot...
Every fall I remove my deck and clean everything up. Often there are grass & grease stains which are hard to remove. This year I used Vim Cream which is used to clean bathroom tubs etc. It is non abrasive but boy does it clean up things with little effort. Its great on plastic and rubber...
I am looking to purchase a Tektite cab for my BX2350. Has any one on this forum purchased one of these from Tektite? I am from Canada and they are manufactured in Manitoba.
ROPS Tractor Cab Manufacturing by Tektite
I am having problems in starting my 425
Everything is clean! New spark module.
It will flood very easily. Usually starts if not using choke and throttle on lowest. If it doesnt start right away......I must leave it and try again later. If I use throttle and choke on inital start it makes it...
Have a chance to buy a good used BX2750 front mount snowblower complete with quick hitch that came off a 2003, BX2200. I would like to install it on my BX2350. Are they compatable? It has a crank shoot.....Thanks for the help:)
I just lost the digital display to show me my RPM when running........... And also my Hourmeter when I just have the key in the ON position.
It was working fine.............Then after I changed my oil when I was looking for the hours it was blank. Any Ideas...........fuses are Ok
Thx Stu
:) Hi everyone, From Ontario Canada here. This past weekend went all the way down to Iowa to pick up a used BX2350 only 17 hours. I met her on the internet on Ebay. When I met her in person she was everything a man could want! not even a blemish. She didn't mind 700 mile trip home even though...