I have an AgriFab 52" sweeper.
It works quite well.
It cannot have the brushes set to close to the ground or it will not work as well as it is capable of.
I always tell anyone wanting borrow or have me do something with my tractor -- Sorry, I don't have any insurance on it or myself.
Just think if your neighbor or someone else got tangled up in that tiller while it was running.
You could lose everything you own in a lawsuit.
I haven't done anything yet in regards to installing a relief valve until I replace stabilizer section in the backhoe control valve.
It has either crack in the body, or a worn out or damaged spool.
I was able to use that circuit for my thumb by plumbing a diverter valve into it.
I am waiting on...
I found a valve that will work --->Surplus Center.
I wonder if the dump port of it could be tee-ed into the other port on the hydraulic cylinder to eliminate the negative pressure in it.
An inline check valve would probably need to prevent back-flow when the relief valve is closed.
If the...
Perfect timing for your post !
I have the same questions.
Because I read in another forum that the oil needs to be replaced on the negative pressure side of the thumb cylinder to prevent cavitation.
I would appreciate it if someone could locate a vendor for the relief like ROcHE1234 used. Or a...
Would your "local hydraulics shop" happen to sell that valve on the internet ?
I have searched quite a bit on the internet and cannot find anywhere in North America that sells them.
I need one that has 1/2" or SAE 8 ports.
This is the only tire plug that will never leak.
The dealer may have put tube in your tire because it may have unseen damage inside of it.
It is not unusual to insert a wick type plug at a different angle than the puncture and that creates another hole inside the tire for air to escape.