Recent content by Suki

I will relay your message. The pressure relief valve has been tested and we even replaced it without adding shims, but seems that is after the filter and didn't stop the pressure. Next step is to see if there is a stuck valve.

I ll keep you posted.

You are correct

spec is 1800-1850. It is happening before the filter. Replaced complete relief valve with no shims. Once fixed, we will add back. Our hydraulic friend has done some research and we will start with finding if a valve is stuck.

the backhoe wasn't on the tractor. It had been disconnected two weeks before 10 hours of running time. It is after the reservoir I believe, not know terms, but they said on the low side. Our hydraulics friend said checking the pressure after the filter made now sense. Needs to be checked...

Do you think they would be the same for a 2006?

It opens at the gasket and it destroys the inside.

Excessive flow is going to hydraulic filter.

Thank you for the info. Our friend is finally looking at it. The Kubota dealer is three weeks out. He is a hydraulics guy and his research has sent him to a stuck valve possibly. No shims were added and a pressure test at bucket was 1250 when it blew. He says checking pressure at that point on...

Have used all before. Mowed and worked the bucket for 10 plus hours before it happened, and then it happened again.

Kubota stuff only, but Kubota is checking to see if right filter as this is a 2006.

No old gasket.

So the hydraulic fluid but will certainly let the guys know. Our friend, a. hydraulics guy has been doing some research and after all the testing, thinks a valve may be stuck. Also, not sure why the pressure test happens where it does and not in the line itself. Will keep everyone posted. We...

Went with no shims.