Recent content by SuperDuty335

I didn't build the actual auger, but I did gather/build/install the rest of the assembly for a skid steer mounted auger. The auger itself is a 9" diam. with replaceable knives and spiral tip. The gearbox is a 58 horsepower, 3.14 ratio Omni brand with a Chief Hyd. motor with max. torque of 3026...

Most of us here build things for our tractors, etc. and so do I. I have been looking for a safety decal supply and have yet to find anything. Does someone have a source for safety/warning decals for machinery? I know I could have some custom made but that is too expensive.:mad:

Hello everybody. I've done a lot of searching and can't find exactly what I need. I would like to know where to get the pre-assembled, greasable bushings like what Markham uses on their grapples. Their website shows them clearly on their grapples with the grease zerk in the end of the bushing...

Be glad I wasn't wearing my two-piece...

Here is a fence I built for a customer. The wire was in short runs so I used an "h" brace with a solid diagonal, but no tightening wire.

Hello. I recently modified a 3-point quick hitch to fit my skidsteer for using tractor implements. The boom pole is incredibly handy.