Recent content by SuperHerb

I bought something similar to this at my local Fleet Farm...

You mentioned rocky ground, so depending on the size and amount of the rocks, a forward rotation tiller may be of benefit. Reverse rotation makes for a nicer tilled soil, but I've found the forward rotation can ride up and over problematic rocks easier. YMMV I have a King Kutter 72" (I think...

Here is what I used and it worked great, changed the 11+ gal of hydro fluid and engine oil into it at the same time, loaded it into the back of my pickup and then dumped it at my local oil recycler. With two people (my wife and I) it was easy to handle. Got mine at Fleet Farm for about $85 a...

I just did my 2021 DK4710se oil change today and it was a 17mm.....unless I'm remembering wrong.

Wish I could find the DK4710SE ones but it doesn't seem to be listed.

I also recently got my tractor, a Kioti DK4710SE, and my tire width was about 67" and I bought the Kioti (made by Woods) 72" box blade. It's well built. I would not go narrower than the rear tires after using it. It's a bit lighter than the commonly recommended 100lb/ft width at 550ish pounds...

Ok, crisis averted. I found another somewhat relevant thread that talked about hydro locking the cylinder and where he waited an hour for pressure to bleed down and was able to move the lever again. It had been about 40 minutes since I did it so I went out and tried and with some gentle...

Nope, I cannot. I used as much force as I dared to pull the lever without starting to bend things. It is solidly locked open.

I have a new Kyoti Dk4710 with about 9 hours on it. I was just out trying out my new box blade and hydraulic top link. I moved the rear remote lever to the B position, retracting the hydraulic top link. The top link fully retracted and now the lever is stuck in the B position. The rear three...

I just got a new 2021 DK4710SE this weekend and while I'm waiting on the Kioti branded (Woods) box blade I purchased to show up I was looking at ordering a hydraulic top link. I measured the stock top link travel at about 19" min to 30" max. I don't have any other 3 point attachments at this...