Are there any aftermarket AC Compressors that will fit the DK 45C tractor. I have a bad compressor and need to replace it along with the dryer and orfice. Old compressor is locked up.
Thanks
JD
2005 model TX 2wheel drive. When trying to start there is just a click. Have put in new battery, another starter. Can jump the starter by using cable to lower terminal on starter and the starter works. Trying to determine if the key switch is bad. When the safety switch wires are pulled there is...
My front grill that contains the head lights fell out while brush hogging and was ran over by the front time. Needless to say the plastic part are in shambles. has anyone fabricated a grill or any used grill available? Priced a new one at $800. for both grill and headlights. Lots of money for a...
I have a 2005 TX that needs a stearing assembly. Evidently the pinion gears are stripped. JD list the parts price at $585.00 Does anyone have access to aftermarket parts that will fit?
Thank you
J D
I took my RTV 900 to the Kubota dealer in West Plains, Missouri for a 50 hour service. I returned to pay the bill and was in sticker shock. $238.00 with 2 hours of shop labor rate. They changed 3 filters, changed the oil. The windshield was as dirty as it was when I took it in. They did not...
I have a 900 RTV Kubota with the diesel engine. I notice the noise level is higher than I would like. Is there any way to use mats or something to damper the noise level. I have a top and windshield but no cab enclosure. Sure like the machine and it is stout but need to do something about the...
Has anyone had a problem with the drawbar hitch bending on a DK45? I am pulling a pull type bush hog and the drawbar has bent.
It seems to me that the drawbar extends too far beyond the drawbar frame.
Has anyone rebuilt the drawbar frame, you know the frame where the drawbar is anchored...
I have tried 3 times to email Kioti regarding the 1590 FEL using the customer service email contact listed on the Kioti Home page under contact us. The email is returned as not deliverable. Anyboy else have this problem or does someone have a correct email address?
Thanks
J D
I have a new DK45C with 12 hours that I find very difficult to change from 4 wheel drive back to 2 wheel. The push pull stick does not want to pull back up when engaged in 4 wheel drive. Any suggestions?
J D
Just took delivery on a new DK45C and noticed that there is a lot of vibration at 1800 rpm or rpm's above 1800, when on asphalt surface. I called the dealer and he said to check the front tire pressure. Will do that sometime today. The vibration goes away at a lower rpm. The vibration is...