Recent content by the whispering oaks farm

Agri supply carries a disc hiller that might work for you. it would be pretty easy to adapt for what you want to do. here is a picture of it.

The light bar I used was (120W 24" LED Alloy Spot Flood Combo Work Bar Diving Light SUV | eBay) it was inexpensive and works great. One of the things you may consider and probably haven't run into yet is to build a frame for your work lights. they are only mounted to the front though the...

I installed a 22" led light bar and replaced the original OEM work lights that came with the tractor with LED lights, man what a difference! Now I want to replace the original headlights with LEDS. I looked up the headlight and work light numbers but it doesn't cross with anything that I could...

you can stand up and leave the seat as long as you have your foot off the hydro pedal, I added a front and rear cam so I could see the ground, but I have a cab so it won't mess with the video screens.

my tractor with grapple, it just makes clearing brush a breeze.

quick attach is a method to install and remove the bucket that is attached with levers into a channel. I don't know the setup for your particular tractor but you can purchase weld on plates to make a fixed attachment into a QA setup. if you are purchasing a new bucket anyway this is a good way...

I went by an LS dealer and looked over the other models very carefully. I found that my xr4046hc had the weakest setup of them all. right next to it was a 5065 and it had a strong screw type setup that could be set very rigid and still move up and down. it could be adjusted and then pinned to...

is that the 7 pole connector on the back? this is the diagram for my xr4046hc which i would think will be the same. Hope it works for you. just use a 12 volt test light to confirm.

My tractor doing what it does best, working hard so I don't have to.

a sub-soiler would be a good choice. they make them with a tubing feeder(extra money) that cuts a 1" trench. If this is a one time use I wouldn't add the pipe feeder. you could just feed the wire as you go.they are about $150.

it cracked the roof and the aluminum threaded tube came out. I epoxied it in again and it put the bolt back in. there is no metal support to it. I ended up coming up from the mirror mount to the height of the lights and ran a 1" square tube across to the other side. it is now hard mounted and is...

I just snagged a branch with my xr4046hc front left work light and it snapped off the fiberglass roof like a twig. I found out how to open the top from another member, thanks btw, and found out it is just a little aluminum nut cert type thing into the glass top without any metal at all backing...

My lights came out the back of the cab between the top glass frame and the canopy, there wasn't a grommet or anything. the lights itself is attached to a mounting stud. the switches are mounted on the right side below the interior light. you should be able to access the wiring through the air...

I contacted LS about the plug in for the strobe, and you have to buy the whole kit, $200+, so i bought a stobe bar on ebay for $53- it works nice. I had to take a couple of the blank switch plates and mount the controls to the strobe in them. that wasn't too hard but it did take a little...

I built my own step box, here is a picture. Not the same tractor though but it could be sized accordingly.