Is this unit supposed to have positive down pressure or just gravity? Once I set it on the ground it will not lift the tractor. If I curl the bucket I can get it to lift.
I noticed today that the front wheels were not pulling real well. The rear tires would spin when bogged down by the implement but the front ones would not. I raised the front end with the loader and the do spin they just do not have much power when on the ground. In the past the front would...
Is my top-link too short? I went to buy one today but they didn't have a smaller one. I used it last week and the scarifiers would not go deep. Today it was a little better because of the rain. In this photo the toplink is at its' shortest setting. Thanks in advance.
I tried to weld two different size metals together on my mower deck last week. It did not go too well. I was able to get both pieces hot and add the rod. It looked like it would hold but when I hit it with a hammer it came apart. I used a coat hanger for filling material. Do they make a...
I just bought my first full size cutting rig. I have done quite a bit of silver soldering with the oxy-acetylene and a limited amount of tack welding with the orange flux coated rod. I have always used the small portable setups. The one I just bought has the same Oxygen and Acetylene...
I just bought this pto driven post hole digger. I have no idea what brand it is. It came with a 9 inch auger and the gear box seems to be good. It looks like it may have a leak. Does anyone have any idea what brand this is? I am looking for a manual. The only identifying info I can find is...
I have done an exhaustive search through the website on this. It appears that there is many ways to do a fence. I had a few bids and I will not pay the going rate for labor to put in a fence so I guess I will give it a shot. I have to fence two sides of my place. My southern fence line is...
I bought my first used tractor and do not know a bunch about them. I have read the owners manual and logged about an hour on the machine. On my loader there is two bars that slide into a tube. The Woods manual shows them as a parking stand weldment. What is this for? It looks like it can be...
Hey folks. I have been lurking for awhile and just bought my first tractor today. It is used and seems to run good. I just noticed it is leaking around the front gear assembly. I am not sure what the component is called and I tried a general search but I could not find anything with a...