Recent content by Tim's Red Tractor

IMG8890 shows the lines coming from the tractor into the manifold IMG8887 shows the lines on top of the manifold exiting the manifold and feeding the blades and the 4 lines on bottom feeding the up/down, left/right. The solenoids are wired to a remote I have in the cab. If I stand next to the...

The brush cutter is a "TOMCAT articulating brush cutter"

ptsg: The cutter came pre plumbed with only 1 set of lines to connect. Those lines feed a valve assembly with solenoids to activate each function, the flow is continuous to the blade (the blade steals all the flow). I was thinking the same as you. If I disconnect the hoses running the blade...

I just found this pump/increaser combo. Not sure on $$ but I will call them tomorrow. This could solve both issues. https://crossmfg.com/hydraulics/gear-pumps-motors/50t-series I was told the brush cutter needed 10-25GPM. My tractor offers 11gpm, I started by connecting the cutter to my third...

A couple of the pumps say 1000rpm, so I would need a 2:1 speed increaser?

Hydraulic fluid for an articulating brush cutter.

Hello All, I am looking for the biggest PTO pump for my 6-spline 540 pto shaft can handle. I can find the Prince 23 GPM but is there anything above that. I have a Mahindra 2565. Thanks