Recent content by tlblv

Update.. haven't had time to pay it any attention.. will add pb blaster for now.. ordering knocker .. no one sales around here .. will keep updating

Status ... There is definitely a slot cut out where the slide needs to be in order to clear the housing. The slot starts about the center point (50%) of the pump and a bit right (towards front of tractor) at about the 70% mark or so... Lubed up the rod attached to the slide on the injection pump...

Yes, I can reach the slider but not by hand. It's too far back. The slider which is part of the pump is not connected to the linkage. It is not in the "v" or "o" (can't tell which, parts diagrams show it as a "v"). Either way, it is NOT inside that linkage. Manipulated the linkage off the slider...

meant to mention.. I also tried to move the "slider" of the pump while it's in the housing and it will not move.. will try again once I get it out of the housing

... Here's where it stands... I removed the inspection plate and got a lay of the land and see that a linkage connects to the "lever??/rack??/plunger??" of the injector pump. I removed the 4 nuts holding the pump and manipulated the "lever" to get it out of the linkage connection being sure to...

lol... I get it! Believe me, I don't want to go deeper into it any more that I have to... I'll pull it and slide it and let you know.. might be another rebuild in your near future (but i hope not :) )

thepumpguy.. you are correct. There is a small access panel. Inside the panel on the left you can see two gears. Directly in front you can see cams. I'll try to upload some photos tomorrow. I'm having a very similar issue. I'm getting no fuel to the lines past the injector fuel pump... The pump...

Thank you beenthere and pump guy .... I will PM Joe. This is my first tractor and first diesel engine so I'm obviously a bit concerned about the process. Your comment pumpguy makes me feel a bit better. Either they just never need to be removed because they never break or it's so simple... Can...

Hi Joe Know it's been a while since you made this post. Just wondering the result. I also have a John Deere 750 that's having issue pumping fuel