TMGT's latest activity

I've been looking at the 55in Catawaba that's a little heavier so I can use it on the BX and L3240, will be on the heavy side for the BX...

I've been mowing with the BX a few times now, so far I've been very happy with the cut quality. Mowing time is slightly higher but not...

They are back apparently and getting orders out, some people will balk at their past business practices, but they make a good product...

Do you have the SSQA or pin on bucket? If you have the SSQA I like the EA grapple for the 55" lightweight at 215lbs., catawaba has a 55"...

Why does he need the ati QA? The Kubota factory one on it should work just fine.

Most likely, it uses a pulse type lift pump, also referred to as a clickity-clack pump because they have a clicking sound when running...

I built one years ago, nothing special about the blower, but honestly I would just buy a cyclone rake. I can't speak to the newer DR...

You mean RCK60B-23BX? According to the parts interchange, the blades are the same between the 22 and 23. I know of the center hole...

My experience with mounting the Kubota BH is that its very simple, the most difficult part is taking the 3pt components off which isn't...

Thats great it works for you, but doesn't work for everyone. My BH was less then 7 rentals and I have it when I need it, I've used it...

Only during certain criteria/operating conditions, catalyst have been on diesels before dpf and def. Due to the high combustion temps...

I have the 18" and 24" buckets, being that mine was a M4711 it didn't have provisions for a factory thumb so I had to make my own. Still...

They won't be labeled Bradco, or now Paladin. The only ones I'm aware of are the M4011 which is newer and based on the 611B and M4711...

NOx is produced in the combustion chamber, not so much the exhaust, the EGR is there to reduce the NOx by reducing combustion chamber...

I definitely wouldn't cheap out on a linear actuator in that application, I already have my hyd. one so not in the market. You need to...