toot77's latest activity

For hydraulic filters, I have considered the wire mesh to be a stainless steel woven mesh media that does the filtration. Back in my...

Trying to understand what is the best thing to do for hydraulic and hydrostat filters on my two New Holland Shibaura compacts, a 1520...

Correction to what I said above, the timer that he points to under the hood is for the Glow Plug Indicator Lamp and not the glow plugs...

Seems like a shame to spend that much for a timer when you had the seat switch jumpered anyway. I would need to see detail of the...

I have a 1520 that I have put on over 3600 hours. Half of that is with a 5’ mid mount mower and the other half is split between a 5’...

Just bypass it..but keep the clutch switch so you cant start unless its pushed in.

SBA385870641 appears to be a timer relay in the seat switch circuit. I am not familiar with that seat circuit as my 1520 does not have...

I am watching this hoping more get added. My 1995 build 1520 is also a KYB model HVFD-23c23-m. I haven't had the opportunity to...

If you are still trying to trouble shoot this, I believe that the way the starting circuit operates is as follows: (Assuming that all...

The PIN can be found on the left side of the transmission casting down under the left side foot plate. Where are you measuring the...

I believe the front axle configuration of a 1920 is similar to other NH Shibaura tractors. On my 1520, that seal is a two piece seal /...

You might take a look at the bottom of the tractor about in the middle just behind where the front axle driveshaft comes out.. There...

Actually it has been about 130 hours, but as I mentioned above, the bevel gears in my tractors are not precision ground, the gear teeth...

I just replaced both of these seals on my 1520 at 3650 hours for the second time. First time was well under 1000 hours. The seal is a...