If you choose not to drain your hydro fluid with the 50 hr filter change. Double check the drain plug is tight. I serviced two different CK3510H recently and on both tractor's the drain plug was just finger tight.
One new upper center pivot assy is about $100. Labor not included. The part amounts to a 3 point hitch ball end welded to a mounting plate. Grease fittings are on both the upper center pivot and both ends of the dogbone bottom bar. Majority of the hours on my unit are from using an...
Used tractor today to spread a quad axle load of stone. Engine rpm at idle is 1,800 rpm with throttle backed off. Owners manual doesn't specify what rpm speed low idle should be at. Add to the list things that were messed up after having tractor repaired at kioti dealership for 2 hydro oil leaks.
I have replaced both the lower bar and the upper center pivot assembly on my 4500Z Ventrac. Dealer told me it was difficult to change the upper and to drop it off to have them do the repair. I changed the upper out in less time than loading it up and traveling 40 miles to drop it off at dealer...
Posted question in buyers forum and asking here as well. I recently had to take my CK3510HSE in for a repair. Upon receiving it back 4 weeks later it seems the low idle speed is alot higher than I remember. I would appreciate what others observe there rpm is at idle. Thanks
I would like to hear from other owners what you would like to see improved or changed on the CK 2610, 3510 & 4010 lineup.
I really miss not having individual L&R side brake pedals on my CK3510SE like I have had on previously owned other color hydro models compacts.
Last week I traded my 4100 in on a new 2520(needed more power for Aera-vating). The 2520 came with R3's, 62D MMM, 200cx Loader and an I-match. My problem is with tire clearance's. 1. I noticed the lower 3pt hitch bars were dragging on the tires with the I-match installed. 2. The rear pins for...