TractorTech's latest activity

My knowledge is old and broad, not just Fords. I may not know the old JDs inside and out, but the hydraulic system in those are basic...

IF you tractor hydraulic pressure is only 1200 PSI and splitter cylinder id is 4 inches you are only getting about 7.5 ton ram...

No doubt the pressure is too low for the log splitter at 1200 psi, but increasing the pressure of the tractor will shorten the life of...

I appreciate the comments, I try to follow what the manual recommends, but feel sometimes there is over kill. I have been faithful on...

Here's my thoughts: In the absence of any symptoms, a valve lash adjustment at 600 hours is probably a waste of money. Removing the...

https://schmidtinc.com/farm-equipment-parts/online-parts-books/tractor-parts/agco-allis-tractor-parts/?noamp=mobile

Strainer is SBA340500090, #14 in illustration

Welcome to TBN! Most tachometers work off of the alternator by frequency. Chances are, you have a loose or corroded connection. Is the...

Hello tractor tech. I have found what the problem was with the weak lift on the hydraulics and it was a school boy error on my part...

Welcome to TBN! What a plumbing horror show. I started my reply earlier today, but see Harry has answered quite a few things on here. I...

A couple observations. It looks like the tractor had an engine driven pump at one point, and someone removed it and most of the...

Welcome to TBN! No sure about the lift dropping at increased speed, but all indications point to your hydraulic pump(s) are worn out...

Hard to diagnose from here other than to say the pump is bad. Is the loader jerky, hesitant? Is there noise from the pump? You may be...

Well, it's your tractor.

You're looking at it, I'm not. That said, you may be looking at way more work than necessary. Many of us have installed seals in many...