TractorTYMe's latest activity

I've worked mine pretty good, but not bent anything yet.

This procedure is known by most GOOD TYM experienced mechanics. Agree you shouldn't had to experience what you did. I'm fairly...

I dont know, i shattered the front windshield on by dk45 2 years ago, and kioti only charged me $550 for a new one. My local glass...

I dunno, but we got GREAT hot water and it's hard to run out.

What JD model did you compare it to?

JUST curious, have you tried this procedure to reset the DPF controller?

The handthrottle can be used as usual, until you press the pedal beyond what hand throttle is set at then it will increase rpms further...

Just on a footnote on TYM's, rather than under-building their axles I think the correct statement is the probably over built their...

My hot water heater is from Hubermeyer Foundry, Seattle 1949. Still cooking, but if it blows? It probably level my house?

Flail mowers rely on a somewhat "venturi" effect to mulch the material. So much over 5'' it will not work well as there is too much...

They put so much plastic @#$%^&* on engines these days. They're not meant to last, 80-100k then buy new. VERY environmentally...

So far I've not heard of that, and VERY few tractors have hub problems on the rear.

Get Brotek spacers, they are the best bang for the $$$, I put 1.5 spacers mostly to make room for chains in the winter. But added 3''...

I'm rocking a 2004.5 with an LLY currently sitting at 224k miles, not much rust and no blow by in engine. Occasionally a no start...