Recent content by trentonford3000

I have a honda 250 r it is getting gas and spark but wont run. it keeps fowling the plug. so i replaced the plug and the same thing. it doesnt even try to fire not even on carb cleaner

I am starting a thread that i have never found. what size snow blower should i run on a ford 3000 it is an 8 speed two stage clutch. There will be alot of drifts for it so i dont know what is better a single auger (large) a single auger (small) or a dual auger. Forum are some with teeth and...

Well i have a ford 3000 which i know diced the rpm gauge is not working it will spin all the way to 2600 rpm once the tractor starts and doesnt seem to matter where the throttle is. is it as simple as just replacing the cable or the whole dash panel. the fuel guage does not work but it hasent...

I have a ford 3000 with a three point that will raise all the way to the top even though the lever is only 3/4 of the way up but below that works properly and no the draft control is not on. any help will be greatly appreciated:confused3::tractor:

I have a dearborn plow that i would like to paint but i was wondering if that wheel that runs on the furrow is needed or will it work without it how important is it were they really needed or will it plow the same without it i would like to get it on before i paint the plow if it is...

I went to a plow day and the ground was extremely hard i was having troubles with the tractor bouncing and jumping keeping the plow in the ground and the bottom kept tripping but i think i figured out the problem with that.it is a ford 3000 with a massey ferguson 2-16 Are there any tips tricks...

i want to check the hydraulic fluid level on a ford 3000 it has a loader that is ran with tractor pump and resivour

i am looking for a set of spindles for a 112 john deere mower deck does anyone know where to get them?

will a ford 3000 pull a 8 foot ford disc and/or lift it i am thinking so since it will lift 1700lbs

i was wondering if a ford ecoboost has the power and torque to pull a 30 foot fifthwheel camper with a boat or a 22 foot trailer with a ford 3000

i have a fasco loader on a ford 3000 and i was looking for forks accept there is only one cilinder to dump so the bucket has only three hook up points and the bucket isnt strong enough for tighten down bucket forks are there other options or would i have to make my own i have a good design...

what oil should i run in a ford naa (summer use only)

i have a 60's ford 3000 with fel the loader is ran off the tractor pump it raises and lowers at an ok speed and the front ram comes back quick but it dumps VERY SLOW the loader is a fasco with one dumping silinder thanks in advance for any help