Recent content by TTTTTT

I'm in the Bancroft area. Up here if in decent shape and running good. Those are getting anywhere from $10,000- $12,000 CAN maybe more. The after market has gone crazy. If you want to get rid of it soon, $8-10.

KEZE 1200 Pcs 24 Size Universal Rubber O-Ring Assortment Kit with 4-Piece Precision Pick and Hook Set for Auto Vehicle Faucet Plumbing Pressure Washer Air or Gas Sealing Repair OD:6mm-28mm Oring… Amazon.ca From Amazon, pretty cheap.

Use L3 L4. Not quite like H1. But not too bad for speed if you're looking for that.

White smoke=generally unburnt fuel. I'm thinking a bad 1 or more injectors. If they are dribbling. This would also give the hard starting symptoms. Easy and cheap to do. Dave

Just to add, my DF (Dong Feng) has a common sump for gear and hydraulics. I've used TDH since new (2008). Works perfect. Hydraulics a little slow until warmed up in winter at -20C. But not bad all.

A little late to the thread. I did this for my DF354. 14 years later still works perfect. My intentions was also for a grapple. Never hooked one up but for my snowplow angling. Perfect https://www.tractorbynet.com/forums/index.php?posts/1770751

Yes should be. It's an open centre system. The engine continuously drives the pump . It circulates getting suction from the sump and pumps through the entire system. When you activate a valve, 3pt, fel or other your forcing fluid to activate it. At high pressure up to 2000 psi. depending on your...

#1, check level. If low you will be sucking air and getting that effect. I'm sure you lost a bit after doing your cylinders

Ok I have the identical problem. Every so often I will have to start it at the starter with a screwdriver. Works np. So you're saying the key switch could be bad not getting enough power to the solenoid intermittently. I always thought the solenoid. It's very random. Could be cold, hot, using it...

Interesting. You are correct about the pins. My plow is a very heavy all steel 8'. Occasionally I do tip it down. Did that work awhile back. So far with all the stresses no breaks. I have caught the edge of the many times but so far all good.I added a cushion valve to my front setup. It has...

Not the greatest pics. Bad resolution , but you get the idea. I can get some better ones off my PC if you want.

Like I, works quite well. I can pick up and drop attachments just by removing the lynch pins

Those brackets are what's on my bucket. Might try to get some of those for other attachments. Here's my front of my loader without the bucket. The rod across grabs top hooks, the pins go into the brackets . When I fabricated my attachment I welded a piece of square tube with one side cut out...

My Dongfeng DF354 has a similar standard Quick attach setup but with only 1 lynch pin on each side not 2 . It's a copy from earlier (not too early though) John deere standard quick attach. I have fabricated a match for some of my accessories including my modified snow plow. Did similar for dome...

https://www.tractorbynet.com/forums/index.php?threads/446274/ Here's a thread someone recently did