Here is a chain and tool holder I figured out if you have a loader like mine on a kubota. Total cost less than $20. take a 4 inch or so section of 4 inch sewer pipe and grind or rasp a bevel on the end then drive in with a board and hammer. Mine was a tight fit but on my buddys m4700 we had to...
Will a small mig like the hobart 140 weld aluminum without a spool gun and is there a spool gun to fit the 140. I am not planning on doing much aluminum but thought it might come up once in a while
I just purchased a new 5740 and am wondering if this is normal. On a steep downhill the hydro trans seems to give and go while holding the tractor back. I have a 4610 with hydro and in the same situation if you hold the pedal at a certain point it will hold you back at that exact speed. the new...
I am thinking about buying a 115 volt welder for home. I have done a fair amount of welding at my shop before Retiring with a ac dc buzz box 225 Lincoln I think. I dint have a good place to wire and set that welder up here so I am wondering what to buy. I mostly want to weld small projects or...