Recent content by VaGlock

I went ahead and installed it as Circle G Tractor Parts instructed me with the tapered side towards the rotating blades, set the gap to specs, They assured me it was the correct bed blade. After running some 2-3 inch branches through the chipper I was not pleased with the way it chipped, turned...

I purchased a new bed blade (anvil) for my model 6 Jinma chipper and the new blade has one beveled edge, the original has 2 flat edges. Contacted the seller and he stated to install beveled edge towards the chipper blades. Has anyone run into this before?

I am at 38 years on a Rudd (Ruddglass Pacemaker) electric tank water heater, one annode replacement. During winter months we turn the electric off and the water is heated by hot water coil in the wood furnace. Have had no signs of rust or sediment build up at drain. We are on well water, and...

I noticed the OP states towing with his Escape, what does the manual state for the Escape's tow rating and trailer brake requirements? I had an older Jeep Cherokee that stated anything over 2000lbs required trailer brakes.

How did they not see that it was bent, when they put it on the balancer!

Was tired of equipment keys shoved in toolbox drawer at back of garage, so I gutted this power box switch and mounted it by the garage man door, put keys on small carabiners and can now grab the key on the way out the door. It is also lockable when vacationing.

At least they don't have to pay taxes on all that fuel!

MY Kubota B2601 has the split pedals on the left.

Our 5 acres of woods (central Virginia) is being taken over by Japanese Stiltgrass, it seems to be killing out all other ground cover plants. It spreads farther every year. From what I have read it is very hard to eradicate.

Found a used 2019 B2601 with FEL /BH that is what I am wanting but it is 350 miles away, was wondering how much I might expect to pay to have it transported to my place? I do not have a way to transport it. it would be a mostly intestate haul. Thanks