Recent content by vanb

I store my cutter against the wall every year, it works great and saves a lot of space in my garage. I just tip it up and use the 3 pt arms to keep it against the wall, I jamb a piece of 4x4 in the floor to hold it tight to the wall.

I've had a King Kutter XB48 for 2 years, no problems. I cut and maintain ATV trails on 200 acres. It cost $850 new.

Years ago when I got my BX I was a bit nervous to take the mower or FEL off, but the more you do it the easier/ faster it becomes. Now every week after mowing, I drop the mid mount mower, put the FEL on, attach my bxpanded skid plate ,connect the 48" cutter or box blade. Then I repeat the same...

Got a 3pt quick hitch to make it easier to use my 48" xb cutter. It didn't work, pins were to low. Drilled new holes to raise the pins so it would work with hitch. Out this evening cutting ATV trails on 200 acres. It's been so wet this month, in some areas that this is the first time I was...

I bought new tires for my bx2350. When they were mounting them on, they couldn't get the rears to not leak slowly. They tried a few times and then recommended tubes. I haven't had any problems with them since. On a side note, love the new turf friendly R4's. Better traction and don't tear up...

I have n Omni hitch, with the quick hitch it was too narrow. I could have got extra long pins and the the Speeco hitch pins add even more length, but it still wouldn't attach at the top without an adaptor or some grinding. I added extra long pins with Speeco pins to all my attachments to work...

My dash panel was kind of working last year. This year it wasn't. I took it out and made sure it was plugged in right. When I do that it works again, then I come out the next day and it's not working. I think I need to get a new dash panel. I wonder if the new 2370 panel would work or am I...

I'm not sure why my photos aren't showing up? I'm attaching them the same way I've always done.

I already had the Omni hitch for my bx, but when I got a quick hitch, I already had a drawbar and would've needed to figure out how to make it fit the new hitch. Instead I just bought something new from Omni to fit the quick hitch and bolt to my drawbar

Got my new 3pt quick hitch from Norther Tool and a draw bar receiver from Omni all put together. I needed to get extended length pins for my King Kutter box scraper and rotary cutter. I also added Speeco quick hitch pins on to reduce the slop when attached.

Well, they came in and I got them mounted and on my tractor. Getting the rear tires on is a PITA, it's hard to line up the holes, hold the tire up/steady and get the lots I at the same time. they couldn't get the rear tires to not leak, so they now have tubes in them. The description for...

http://www.carlisletransportationproducts.com/product/tires/ag-construction/Tires19 I've got a 2006 bx2350. I got talked out of getting the R4's when I bought it. The turfs have been OK, but I do a lot of FEL, box scraper work. I also have hills on my land and the turfs slip easily If the...

Here are some picks from a few weeks ago. Normally I don't use my tractor during the winter, but I was out of town during this blizzard. When I got home drifts were too big and frozen to plow with ATV or use my snowblower. It sure takes a lot longer to move snow with a 48" bucket.

Here are some pics from last year when I bought them. Yes, the 36" forks are solid.

It fits the 243. I have the QA on my bx2350. Fits just fine.