In my attempt to understand the QIV (quarter inching valve) on my 2320 I noted that the right control lever cover that holds the stops is ruined by the stop bolts being wrenched on too hard by the dealer??? I will see if this can be replaced but I noticed a square cover on the same assembly...
Im looking for a 4 pole 1800 RPM head. Need to be able to be wired for single phase 120/240 vac output. Also prefer a single bearing end as it needs to mate to an SAE 4 engine.
Ok, I purchased my B2320 w/ a BH65 backhoe so when I took delivery we were unable to review the 3 point operation. Figuring 3 point is 3 point I didnt care until now... I was able to spend time yesterday to remove the backhoe and to setup the 3 point hardware. Not bad but not "quick" as it...
I need to change the hydro-static filter per the 50 hour schedule of my B2320. It states that the filter only is to be changed. How do you guys change this filter without loosing all the $$$ fluid. Also, it seems the dealer sold me the hydraulic filter and not the hydro-static filter... so I...
Well, we have the B2320 for a little over a month now and its already time for the 50 Hr service... Am I seeing some of the posts here correctly and people have tractors out there that are years old and haven't hit 50 hrs yet??? :confused:
Noticed the one lever on the backhoe was not angled like the other... At first I was worried it got bent by a tree limb or something. After taking the cover plate off the linkage I seen that the two small bolts were loose and almost ready to fall off. These are behind the linkage that goes...