Recent content by waddie62

Has any one built a post driver for a skid steer I am looking for some plans or info if any one has anything I am interested .I wood rather build than buy:confused2:

Does anyone know what would cause the door on my 848 to jerk while closing after the bale is ejected It jerks then slams shut I don't think this is the normal way it should close :confused2:

Is there any tricks to using a 848 going to bale in a few weeks just looking for some advice any would help

Does anybody out there know how to shift a white 2-105 I cant figure it out a picture would help

Done anyone know what the shift pattern is on a whitr 2-105 a picture would be helpful

THE INTERMITTENT GEAR IS LOOSE ON THE KEY WAY WILL THIS CAUSE KNOTTER PROBLEMS

I am in need of gears for the cutter bar anyone have any laying around or a junk mower

Anyone have any gears for a 242 or a junk one they would sell I am in indiana would go 150 miles to pick up

I am replacing the inside knotter on my 14t when i got everything off the shaft i found the intermittent gear is loose on the shaft the key way is worn if i shim it up and it is off 1/32 will that make it not work like it should tie knots

Does anyone know what hp it takes to run one of these am242 mowers properly . I was wanting to use my 3910

How do I bend a knife arm without breaking anything . First time I tried I broke the knotter housing . I just bought a $150.00 housing and I don't want to break it any suggestions can you heat it?

Does anyone know how to shift one of these and find all the gears ? I would like to see a shifting pattern if anyone has one .

i have a massey ferguson mod 41 sickle mower have no manual need to know how to set everything so it works and raises properly