Recent content by Waterlogged

  1. W

    Backhoe  BX24 Backhoe Rock Lifting Capacity

    I am looking to move some landscape rocks around my property in the coming months and I am trying to decide if I should get a thumb. I can use the front loader but would like to bring in some bigger rocks and want to know if the backhoe has greater lifting capacity than the front loader? Does...
  2. W

    OT-Yanmar Generator

    I normally hang out on the "orange" forum (please don't hold that against me) but I have a couple of questions for the Yanmar pros. I picked up a heavy duty Yanmar 5KVA generator with a TS105C Yanmar diesel on it (very heavy bugger-600 lbs?). It's a hand crank model and has been sitting for at...
  3. W

    BX24 Support and Seat Replacement

    I picked up a used BX24 and was wondering whether or not the replacement seat and floorboard supports are warranty items or goodwill replacements from your dealer. I would like to get the new seat for improved comfort and the brackets to prevent breakage down the road. I looked at previous...
  4. W

    Kubota T1400H Engine Made By.......?

    I just picked up a great little Kubota T1400H for $80 to go along with my B7100. I'm trying to find specs on the lawnmower engine but I can't figure out who makes it for Kubota. It's a model GV400V-L (13hp) but that's all I know. I've seen comments about Kawasaki but I'm coming to a dead end...
  5. W

    Kubota Keychain

    Anyone have a cheap little Kubota keychain sitting around that they would be willing to part with? My key keeps getting lost in the drawer and desperately needs a keychain. Yes, it's **** to need a Kubota keychain, but my little B7100 deserves the best!
  6. W

    Kubota B310 Screw Wood Splitter

    Just picked up a B7100 that came with a Kubota branded screw style wood splitter. Has anyone every used one? Are they safe or is that why Kubota (and apparently everyone else) no longer makes them? Thanks all.
  7. W

    TS1610F Front Axle Knuckle Rebuild in Process....Help Needed!

    OK, the front knuckle is apart and the gears look great but there is definately some wear on the bearing surfaces. It's obviously been apart before since the seal is a National (USA) brand. Horizontal play....there is a sleeve in the knuckle. Is this a factory part or was it installed by...
  8. W

    A Few Questions on TS1610F

    Recently purchase a TS1610F 4wd for some landscaping projects and am going over it to make sure everything is going to last for years to come. Only problems I've found are a bad starter switch and some play and leaks on R&L front axles where they rotate with knuckles. The part that has me a...
Top