Recent content by weskar

Owner of a L4240 HSTC, the front wheel studs keep getting loose and fall out. These are turf tires. I check the lug nuts as required the lugs are fine,its the studs that are loose. I have used lock tight with some success. The Kubota mechanic said this is very common problem. Any suggestions...

Question - If a PTO generator is hooked up and running, the operator gets off the seat the PTO/ tractor shuts off. How would you bypass the seat safety switch so the generator can operate?

I own a one year old Kubota 4240 HSTC, garage kept. When the tractor was purchased new the top, fenders and hood has signs of fading due to the harsh Florida sun. The dealer indicated that there is a three (3) year guarantee on the paint. I waited until there was about five hundred hours on the...

How many grease fittings are there on a 900?

I purchased a L4240 HSTC, about three months ago, have been searching for front fenders, with no luck at all. Any suggestions or where to look?

I purchased a L4240 HSTC, about three months ago, have been searching for front fenders, with no luck at all. Any suggestions or where to look?

I have a Toro Z-150 zero turn with a 20hp Kohler, the engine runs fine, recently the pto/ electric clutch has been has been disengaging - engaging. I can't seem to find a wire or any loose connections. Any suggestions ?