Recent content by Wnc3

It Should have rolled. I think the hitch pin held it. I still don’t know how why this happened, I was not the operator. Winch truck doubled line and got it out.

I have started using the Ford brand cetane boost in my 2014 F250 6.7 engine. Has anyone found that this additive or any additive has helped to lower the exhaust cleaning frequency or made the exhaust sensors last longer? (Our work trucks seems to have less problems than mine, but I really think...

I have started using the Ford brand cetane boost in my 2014 F250 6.7 engine. Has anyone found that this additive or any additive has helped to lower the exhaust cleaning frequency or made the exhaust sensors last longer? (Our work trucks seems to have less problems than mine, but I really think...

These are Run Cool Hood Louvers mounted on a Ram 3500. More time consuming to install and more expensive , same effect. And in a hard rain more susceptible to water infiltration. Do they look better? Not sure, I'm just trying to improve a/c and cooling.

We did this to improve A/C, cooling and battery life. A/C improved a lot. Too soon to tell on batteries. Truck idles a lot. Anybody else try this? This was the cheapest way I could think of with no body work.

I have never liked this hitch set up because it eventually ruins the draw bar and it is just an inferior design. I have thought about a ball mount trailer hitch style. I noticed Bush Hog uses a straight hitch, but ariculation is needed for ditch and creek crossing. I am open for a solution or...

I had the B&W setup in a Ram 2500 , 2006 and liked it. Now I have a 2014 F250 that does not have the GN factory hitch ( I think it is a Reese) and wish it did. That said, do I install the B&W or go with something else? Thx

Here is the report. 35% left of undercarriage more or less

Here is a picture.

I am in the market for a small dozer for road work, erosion control , brush clearing and maintaining creek crossings on our place, not commercial work. When everyone seems to be going to mulchers, I'm looking at a dozer... I have found a D4G with cab and air, sweeps, window guards, wide tracks...

I'm considering a mini skid steer stand on for light material handling . I like the idea of easy on and off for operator. Would use forks primarily. Brands are Toro-dingo, vermeer, ditch witch, boxer . Any suggestion on brands?

Should I option the 3:73 rear end ratio instead of 3:55 with the new 8 speed transmission? Will fuel mileage suffer much? Mostly running unloaded, but would rather have a little more snap off the line and Tow ability. 80% city driving.

I have been considering this conversion kit offered by Dynatrac for a while for improved mpg and less wear on the front drive line and axle. They feature warn premium hubs ( or theirs for another $400) and the hub asembly with replaceable bearings (stock is a main unit bearing which has been...

My 3520 must have a problem in the control valve. It has the electro diverter switch for the remotes, in my case top and tilt. If I let it sit with loader raise it will drift down 8" in an hour. Same with the top and tilt. Anybody else had this problem on the 3x20 series?

My galvanized tank rusted out and I would like to try stainless. Does anyone have a good source? If I can't get stainless, I will go with fiberglass. I don't want a bladder, just the tank. My tank lasted only 10 years and we have good water... Thx