Recent content by woodsroad

  1. woodsroad

    CC HDS 2165 Electrical Harness Connector R/R

    Never heard of the place. Their retail stores are all in the Minneapolis area. Neat stuff!
  2. woodsroad

    CC HDS 2165 Electrical Harness Connector R/R

    Richard, I'm going to put a piece of heat shrink around the back of the switch, overlapping the harness heat shrink. The switch is getting replaced because the headlight position is iffy.
  3. woodsroad

    CC HDS 2165 Electrical Harness Connector R/R

    The Rest of the Story: I finally had some time to finish this job: Prep new wire: Strip, crimp and solder. Add heat shrink Insert spade connectors into the plug body. Some more heat shrink as a strain relief. Splice the new plug assembly into the existing harness. Add some 3/4"...
  4. woodsroad

    CC HDS 2165 Electrical Harness Connector R/R

    https://www.amazon.com/gp/product/B08F3ZM6Z9/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1 I've used these solder heat shrink butt connectors on my trailer, and they've held up well. I twist the two conductors together.
  5. woodsroad

    CC HDS 2165 Electrical Harness Connector R/R

    OK! Sorry for the delay, but work intervened. There isn't much slack in the wiring going to the ignition switch connector. When I cut off the bad connector and put on the new one, I'll lose another couple of inches of wires. I have the connector that Richard suggested above, and so I bought a...
  6. woodsroad

    CC HDS 2165 Electrical Harness Connector R/R

    Richard, thank you so much. I didn't think that a "dumb Google search" would uncover a direct hit like that. Very much appreciated!
  7. woodsroad

    CC HDS 2165 Electrical Harness Connector R/R

    The red and white wire is the iffy one. It goes to the melted pin. Thanks!
  8. woodsroad

    CC HDS 2165 Electrical Harness Connector R/R

    Yes! I should have done that. I'll get a photo of the connector posted tomorrow.
  9. woodsroad

    CC HDS 2165 Electrical Harness Connector R/R

    Hello! The electrical connector that goes to the ignition switch on my CC2165 needs to be repaired or replaced. There is one loose connection in it, looks like the ignition wire (red/white) and it appears to have been melted at one time. I don't want to replace the entire harness, I just want...
  10. woodsroad

    Owner reviews of CK2610SE HST

    Hey, Lee. Did you take those videos down?
  11. woodsroad

    Do I need a return AND suction filter?

    Hello, I'm rebuilding a log splitter. It has a 16 GPM pump and 5" cylinder. The return filter was undersized, and I have replaced it with a filter that exceeds the flowrate of the pump. The reservoir tank does not have a suction strainer. I have added a good breather/filler cap, however. Do I...
Top