Recent content by woody

my gate is only 900 ft. from house and I installed solar with a deep cycle battery, I still charge the battery about once every three months it would be less but we don't want to cut more trees for more sun light to get in. I also modified a subsoiler for direct bury and to lay pex water line...

Sounds like a project and move worthy of some pictures, let us watch

I have moved a couple of buildings that did not have skids, the smaller ones I dragged them on my trailer anyway, but the ones that were wider than my trailer I jacked up and backed the trailer under them. I have not tried it but that might be a good time to add the skids.

The building mover called me back and it seams there is over $12,000 still owed on the building. I Ran fast as I could!

I was told by the building mover that he would have to check some data base to make sure it is paid off before he would agree to move it. Wish I could check it, I guess I'll wait till I hear from him. The building looks in good shape but it shows signs of being moved a few times when I asked him...

I was told that but after doing some research I found 20 pounds per square foot to be more realistic if the inside is not finished. I figure about 11,000 pounds.

I think I agree with WM75Guy I don't have the right equipment.

Not sure how tall it is but it is a single height, I have moved a few smaller buildings and gazebos, yes it is a portable Graceland building, I think for a $1000 I would let someone else move it. portable Graceland building

okay this might end up in Hauling or Towing Something Wrong thread, but I was told about a deal on a 14 x 36 building, it's only 5.2 miles from my house and only 2 miles on a main highway the rest is a back road. The building mover wants 1800 dollars to move the building but I have a 14K 20 foot...

I make sure to never leave the battery in it, I use vinyl gloves when I grease and when I'm done I wipe off the gloves and slide the grease nozzle into the finger hole then sit on a rag on the shelf.

that's neat if I tried that with my Phantom 3 standard it would be trashed.

Mine was a bad seal on the pump and it did not leak a drop. That being said I don't believe it's your pump must be something you changed or cleaned or maybe over tightened, hopefully yours will show itself in the form of a small leak.

need to figure how it got milky is it water contamination or is it sucking air some where? My B26 was sucking so much air it was foaming out the vent and looked milky. Is the level higher than when you last checked it. Was the oil you drained out milky looking?

Last one I replaced I bought from a dryer repair shop, he had one on the shelf

Okay the guys from the power company showed up yesterday and said everything looks good so they connected me right up I now have my power under ground from their pole to my house. I told them I capped the end of the conduit to keep water out until they got here and they said it would not have...