WranglerX's latest activity

I have a STIHL FS90 which is a 4 stroke and it uses same 2 stroke mix as my chainsaws.... In a sense it does not need oil and like...

Check the screws the hold the gauge unit to circuit board..... When mine was delivers the temp gauge did not work.... What do you know...

And we need to rename PG&E to Pacific Graft & Extorsion....

Not so much about local utility company BTPM, extract (pdf file) gives pretty good description of what appliances draws how much power....

Living in rural area its common for 22-25 KW generators run on propane, common installation usually with a 250 gallon propane tank and...

Does not sound like like correct answer to my question.... What is generator output breaker size???

Maybe I missed something, but all comments are about a 9KW generator, BUT what is max size of circuit breaker on output....

What type of cable is it (look on the cable jacket) and what Temp rating in C is it? That will determine your Max amperage rating. NEC...

According to wiring diagram there is one single black wire that supplies most grounds for most dash functions... It s on the connector...

And what is gauge of cable you are connecting generator to transfer switch..... Bottom line with 30 or 50 amp generator ( maybe 10KW)...

Might be in owners manual, I know it is for 17xx series....

Might check to see if there is a "starter relay" in circuit.... Electrical diagram in manual would tell you this.... I know in GC 1700...

Justy a FYI, the NAPA filters are manufactured by WIX...

That little bar is a key. All it is supposed to do is keep the pulley from spinning on the shaft. The locking is done by the set...

Several loader manuals recommend a 3pt counterweight in pounds, that works out to about 2/3 to 3/4 of the lift capacity. Bruce