Recent content by wrenchless

I wouldnt worry about throwing it out of balance, you would have to put considerable amount of weld to effect balance much

Yes, fluid level was first thought too, i found problem, it wasnt obvious, it was under top cover that holds main valve for 3 point, the return from accessory vales were full of brass that eventually got into check valve in main valve, i took valve completely appart and cleaned it, works great...

Check out husqvarna saws but look at commerical series, way better saws

I have L5030 kubota, 3 point wont raise until i raise RPMs a lot, doesnt respond until lever is at top of travel, i have changed both hyd. filter, looked at releif valve, all good, looked at check valves (2) all good, was told to open fill cap and have someone work 3 point lever, i can hear it...