Recent content by xmoto

I am going to my dealer tomorrow to put a deposit on a L3800 with a LA524 loader. Are you guys or gals that aready have one happy with them? Thanks

I am looking at a MF1160 and I have noticed there is very little information on the web for this tractor. Can you still get parts for them, were they a good tractor? It seems that if there is not that many of them around there must be a reason. Any info would help.

How wide is the 1910. outside to outside of rear tires. Thanks.

Hello, I am looking at a 2006 TC30 with 200 hrs on it. NH loader and hydro trans. I was all ready to get it then I started reading all these post about the bell housings cracking. Should I stay away from this tractor?

I have a XUV GAS gator. I am thinking of putting a plow on it for the snow. I was wondering how they push the snow. My driveway is about 700 ft. Would that be to much? Thanks

Just some info to share with the forum. I have a 2009 XUV. My land has a lot of hills on it and one is very steep and you have to go up it slow. I kept getting error code 24 which is the ground speed sensor and it would put the mechine into fault mode where it would run on one cyclinder which is...

Has anyone made there own hard top for a xuv.

Has anyone made there own hard top for a gator XUV.

Hello I have a 2009 620 XUV with 9 hours on it. I was climbing a pretty steep hill with no load in low range and it just made it. The tires didn't spin it just almost stopped moving. It was a steep hill but I was surprised it had a hard time with it. My buddy has the same machine with 200 hours...

Does anyone know of any good places online to buy tractor tires.

I bought a used L3410. This weekend was my first cold morning and the glow plug light didnt come on and tractor wouldnt start. I read in the forums about putting in a solenoid and switch to work the glow plugs manually. Does anyone of a copy of the wiring diagram to help me do this. Thanks

I HAVE A NEW XUV 620. IN MY WOODS THERE ARE A LOT OF PLACES I HAVE TO GO VERY SLOW. IT SURGES AND IS HARD TO DRIVE SMOOTH AT VERY LOW SPEEDS. IS THERE A FIX FOR THIS. MY BE A LOWER CLUCH ENGAGEMENT SPEED? ANYONE HAVE ANY IDEAS.

WOULD A GEARBOX FROM A BRUSH HOG WORK FOR A STUMP GRINDER PROJECT? ANY GEARBOX SUGGESTIONS. I USUALLY GET MY STUFF FROM EBAY.

Has anyone thought of making a trencher/stump grinder to fit on to a backhoe attachment. It seems like it would have a lot of great uses.

Dose anyone know if the new new style tailgate will be avaliable of older gators. I just bought a 2009 and now see the 2010 gates.