Recent content by YotaBota

This dropped out when I removed trans oil drain plug. Can't be good, WILL NOT BE CHEAP.

Out tilling this evening and BX25 seemed a little sluggish backing up a few times, but forward seemed to have been fine. Thought it might have been an issue with tractor being in low range so shifted into high range with no difference backing up. checked to see if there was dirt impeding the...

Hi. Went out this morning to put on my front end loader and I only can move the up and down, can't curl the bucket. FEL has sat out all winter uncovered and its -20 something today. Any thoughts as to what I should/could check? Tractor and FEL are only 3 years old and not used very much. I have...

Yikes! Hopped on the Bx25 yesterday and, what! no brakes. Pedal goes 3/4 down to the floor before anything happens. I think that my helper may have left the emergency brake on and mowed the lawn. Any ideas? Any adjustments that can be made?

I know this is somewhere on the forum in the past-BUT I can't find it after searching for nearly 3 hours! I am looking for help with part numbers, pictures, and some guidance so that I can add a hydraulic chute rotator to my 2750D snow blower. Who has done this project? Buying the OEM Kubota...

Couple of quickie pictures of the toolbox and bracket fabricated for my BX. It's an ammo box bolted to a 3/16" plate steel bracket. The box and bracket were sand blasted, 2 coats of POR 15, 2 coats of spray bomb gray primer, and 3 finish coats of Kubota orange. Actually twisted apart my 1/2-3/8...

Out mowing late this afternoon, its only about 80 here, and temp gauge got to the break between the white zone and hot zone. I had blown out the rad last week when I was finished, so it is pretty well spotless. Noticed recovery bottle is half full. I am running a 54" mower deck, grass is...

Well I have been using these dollies that I got from BXPanded for a few weeks now, and I MUST comment that they are well manufactured and work incredibly well! As do the clamp on forks, and light kit I got last year! Bravo Harry! Great guy to deal with on the phone too!:thumbsup:

What is the difference between a single stage and dual or 2 stage snowblwer? (Other than cost) I am consider a front mounted unit because I don't like being turned around while I am using my back blade, but the front mounted units are single stage and the rears are 2 stage. What's better? We get...

I am considering adding a hyd toplink for my BX25. How easily is this done? Thanks for the help.

Is there a hydralic adjustment for the backhoe? This tractor BX25 is about a year old and it just seems to take forever to dump. Been like that from delivery. Don't use it that much, but this weekend it just irritated me enough to ask. Thanks for the help.

Bx25 is just over a year old and I can't figure out why once the tractor has been used for an hour the hydraulic groan/squeel when they have reached the top position. At the 50 hour fluid/filter changes, that was all done by the dealer, it was still present, and I have checked the fluid level...

My buddy is telling me that his less than 1 year old CT225 doesn't push snow anymore than 8 or 10 feet then just stops dead in its tracks. He's got about 300 feet of driveway that took him over 5 hours to clear. That just ain't right. I told him that he's prolly got his bucket down too low and...

This sort of came up under another thread earlier today...that being the idea of a dealer throwing in a hat, or a jacket, or collectible toy-whatever, to the new buyer, as kind of a thank you. A handshake is great, a must, with the heart felt thank you. BUT, when you got a guy (or girl) that is...

I would like to put a door into the exterior wall near my fireplace to hand firewood thru, so I don't have to walk up the stairs, and thru the house, just to get the firewood to the fireplace. Actually, where I want to put the door, there is a cabinet base that is large enough to store the wood...