Recent content by Yseesee

I've had this tractor since Father's Day 2007 and I never posted a picture of it so I thought it was time. It just went over 73 hours yesterday morning. I have been very impressed with the performance of this little beast. So far I haven't found a task it couldn't handle. Prior to this...

I just picked up a new 16' foot trailer yesterday morning for my 2520 and I need a little advice. I'd like to know where the tractor tie down points are and the proper way to use them. I figured the tow bar would be a good place to secure the rear of the tractor but I'm a little confused about...

I have the 200CX front end loader installed on my 2520. The other day I noticed the bucket level indicator was really loose. I looked at the 15/16 nut that holds the level indicator in place and it appeared it wasn't tight enough. I didn't see any treads showing it almost looked like it was...

When I remove my 62” MMM from the tractor, attach an implement to the TPH, and try to use the implement in the lowered position the arms that are used to lift and lower the mower deck practically drag the ground. I’m really afraid these arms going to get damaged and I can’t figure out how to...

When I hook up a rear implement to my 2520 I seem to be having problems with the three point arms hitting the rear tires. Anyone else having this issue, if so, how do I properly adjust the turnbuckles? I’ve only had the tractor for a couple of weeks and I can’ seem to get this setup correctly...

Well, I’m still waiting on the delivery of my 2520.:mad: I’ve been getting conflicting information about the throttle position when using this tractor or any other diesel powered machine for that matter. I’ve heard people say “Always open the throttle all the way up and control the tractor...

Well, I have been spending a lot of time at this site over the past few weeks. I have been gathering as much information as I can and comparing tractors from the different manufactures. I finally made a choice and I ordered a John Deere 2520 with a front loader and the 62” drive over mower...