Recent content by z28clone

Well the fix isn't what most of you would prefer, but I won't use the pto much and saved me alot of time without messing with the clutch or splitting the tractor. I was correct thinking the pto gear wasn't engaging inside the driven gear. So I ground the top end of the pto slot about 1/2" so I...

Dual stage clutch. With implement connected I disabled the pto safety switch so I can see if pto will run when tractor is off then start it with pto engaged. But with pto lever engaged the pto doesn't spin and will still grind if I pull up on the lever to the highest point in the slot. It acts...

The rear PTO will engage fine with nothing attached. But grinds when an implement is attached. I managed to get it to engage twice yesterday with no grinding, but not sure how. Pto Lever moves easy and only grinds at the last 1/4" of the top position. I read other posts and looked at the bolts...

Leaking fluid from the input side of the main 4x4 drive shaft /output side of the transfer case. I went to JD parts catalog and cant find the part number. Any help appreciated.

one pic is pto from the S-373 and the other is from my S-370D with the coupler on it for the Backhoe pump. Do I have a PTO reverser on the S-373? Is it easy to remove and put on every time I want to use the tiller?

I have a problem that most Satoh owners wish they had. I have an S-370D Beaver with front end loader and backhoe. I just bought an S-373 Beaver with a tiller. Tiller is a 1110S model but what I didn't check before purchase was the PTO rotation. My S-370D PTO turns CCW, this newer Beaver turns...

Just got Grandpas ol' cub motor rebuilt. Hooked up woods belly mower. PTO probably hasnt been used in 10 years. While mowing, about every 5-10 seconds, the PTO handle makes a grinding noise. Then all of the sudden the PTO pops out of gear and starts grinding, but the handle is still in the...

Moving dirt with the tractor with a Blackhawk loader. No wheel weights or weight in the back, so I had to lean alot to keep from tipping. Anyway, I push in to grab a pile of dirt and I hear a snap. I thought it was the loader creaking a little. A few minutes later, I notice my front left wheel...

Groaning noise when I push in the clutch. It grinds when I put into gear. It isnt stuck to the flywheel, because I tried to start the tractor in gear with clutch pushed in and it doesn't move. Is there an adjustment, or do I have to split it? With this clutch issue and possible hydraulic issue...

First, I hope I got a good deal. Bought a late 70's 370D 4x4, FEL, backhoe and brush hog for $3500. Seems to run good. FEL is sluggish up, down and bucket. What do you guys think?

Lawnmower has been driving fine, no noises, etc. Noticed that my trans oil resevoir was empty. Put oil in it and mowed more with it. Low again. Turns out my left trans was leaking on the bottom. Drove the mower in the garage and Pulled off the bottom plate to check the o ring(looks like this is...